How to carve a jackolanter



We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

First gather your necessary supplies for carving a pumpkin. This includes a knife, spoon, paper towels, marker, candle and, of course, your pumpkin.

Once you have gathered your supplies, cut the crown off the top of the pumpkin making an open circle at the top.

Then, using your spoon or knife disconnect the seeds from the pumpkin within in order to make your pumpkin free of its contents.

Using your spoon again, scoop the disconnected seeds onto a few paper towels.

For the face, start with just drawing the eyes with your marker.

Also using the marker, draw a nose.

Finally, draw your mouth.

Then using your knife, carve out the eyes, nose and mouth making sure that an opening is made to see inside of the pumpkin.

Then place any neutral color candle within the pumpkin.

Then using a lighter or match, light the candle within in order to illuminate your jack-o-lantern.

With the earlier removed crown, replace it above the lighted candle to make it look as though it had never been removed.

Finally, place your jack-o-lantern on your porch to spruce up your house for the fall season holidays.


Watch the video: FALLOUT 76 TOP 10 MOST RAREST OUTFITS YOU WANT u0026 HOW TO GET THEM!


Comments:

  1. Mishakar

    not bad

  2. Taron

    hmm ... well, this is already extreme ...

  3. Shakashura

    I confirm. This was and with me.

  4. Illias

    As always on top!

  5. Gringalet

    Author, are you by any chance from Moscow?



Write a message


Previous Article

How to make serrano chili chicken wings

Next Article

How to make a wooden cutting board